All posts tagged "cutters"

  • Featured tool June 10 – German Plier Set

    by Narlene Allen, Wire-Sculpture.com Tool of the Week for June 10, 2013 This week’s tool: German Lap-Joint Pliers and Cutter, 4 Piece Set #PLR-400.99 Video by Kate, JewelryTools.com This week’s featured tool from JewelryTools.com is the German...

    • Posted June 10, 2013
    • 0
  • Wire Jewelry Tip: Sharpening Wire Cutters

    by Rose Marion, Wire-Sculpture.com Jewelry Resource for April 3, 2013 Open Topic: Caring for your Cutters Here’s a discussion topic: what do you do when your wire cutters start to become dull? I talked to Megan, our...

    • Posted April 3, 2013
    • 13
  • Featured Jewelry Tool Aug. 13: Lindstrom RX Ergonomic Cutter

    by Rose Marion, Wire-Sculpture.com Tool of the Week for August 13, 2012 This week’s tool: Lindstrom RX Ergonomic Small Oval Head Flush Cutter, #PLR-8141RX Video by Kate, JewelryTools.com This week’s featured tool from JewelryTools.com is theLindstrom RX...

    • Posted August 13, 2012
    • 0
  • Featured Tool April 30: Italian Flush Cutters, 5 1/2 Inches

    by Rose Marion, Wire-Sculpture.com Tool of the Week for April 30, 2012 This week’s tool: CHP Milano Italian Wire Flush Cutters, #PLR-487.00 Video by Kate, JewelryTools.com If you’re looking for a quality flush cutter at an economy...

    • Posted April 30, 2012
    • 0
  • Daily Wire Tip: True Flush Cutters

    Daily Wire Jewelry Making Tip Question: I’ve bought several wire cutters that said they were “flush cutters”, but I still am left with a definite sharp point on my wire. I’m beginning to think I don’t understand...

    • Posted September 21, 2011
    • 20
  • Cutting Steel Pattern Wire

    One of our newest products is Steel Pattern Wire, great for making wire bangles, collars, and cabochon frames. You might find it a bit tricky to cut, because it’s tougher than Xurons and even Tin Snips –...

    • Posted May 26, 2011
    • 13
  • Daily Wire Tip Feb. 9: Flush Cutting Jump Rings

    Daily Wire Jewelry Making Tip for February 9, 2011 Question: What flush cutter would you recommend to use in making jump rings? Every one that I use has left the cuts pinched, not cut flat like the...

    • Posted February 8, 2011
    • 9
  • Daily Wire Tip Oct. 10: Cutting Jump Rings

    Daily Wire Jewelry Making Tip for October 10, 2010 Question: When cutting jump rings, how do you have a flat surface on both edges? Am I using the wrong type of cutter if one side is always...

    • Posted October 9, 2010
    • 12
  • Daily Wire Tip: Wire Jewelry Tool Care

    Daily Wire Jewelry Making Tip Question: I’m just getting started in wire jewelry and have a selection of beautiful new (and expensive) tools.  Can you give me some tips for keeping my tools in prime condition? Answer:...

    • Posted May 11, 2010
    • 13
  • Daily Wire Tip Dec. 18: Cutters for Half Hard Wire up to 18 Gauge

    Daily Wire Jewelry Making Tip December 18, 2009 Question: What cutters are good for half hard wire up to 18 gauge wire? Answer: My absolute favorite wire cutters are the Xuron Maxi-Shear flush cutters, which Wire-Sculpture will...

    • Posted December 18, 2009
    • 1