Home   >   Daily Wire Jewelry Tips   >   Featured Jewelry Tool: Xuron Double-Flush Cutter

Featured Jewelry Tool: Xuron Double-Flush Cutter

By on May 27, 2013
Print Friendly

by Rose Marion, Wire-Sculpture.com

Tool of the Week for May 27, 2013

This week’s tool: Xuron Double-Flush Cutter #PLR-469.10

This week’s featured tool from JewelryTools.com is the Xuron Double-Flush Cutter, PLR-469.10.But it’s also available on Wire-Sculpture.com!

I tried these double flush cutters on some 16-gauge wire, and both ends turned out identically cut. There was still a little bit of a bur on each end, but a few swipes with a file and the were smooth, rounded, and ready to go.

These cutters are a great, lightweight tool that eliminates the need to cut your wire twice.

Click here to see the Xuron Double-Flush Cutter
 on JewelryTools.com:

Xuron Double-Flush Cutter

Click here to see the Xuron Double-Flush Cutter on Wire-Sculpture.com:
Xuron Double-Flush CutterXuron Double-Flush Cutter

 

Click to Receive Daily Tips by Email